Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Doro 727
Summary of Contents for Doro 727
- Page 1 ������ �� �������� ����� Manual doro 727...
-
Page 2: Talk Button
��� ��� ��� ��� ��� ���� ���� ��� 1 Redial/Pause and Scroll button 6 Erase/Mute button 2 Recall/Intercom button 7 Programming/Hands free button 3 Talk button 8 Caller ID/Scroll button and Ringer on/off button 9 Phone Book memories and Key Lock button... -
Page 3: Table Of Contents
Paging......... 9 Timer........9 Hands free function .... 9 Memory....... 10 Caller Identification Settings Ringer melody ....13 Ringer volume ....13 Volume control....14 Direct call......14 Recall button timing.... 15 Tone/pulse dialling....15 Reset handset defaults..15 www.doro.com... -
Page 4: Installation
Do not place the base unit in areas where it will be exposed to direct sunlight or other major heat sources. The earpiece of the handset may attract small ferromagnetic objects such as staples and pins, care should be taken when placing the handset near these items. www.doro.com... -
Page 5: Belt Clip
When the telephone is installed for the first time, the batteries must be charged for 24 hours before using the telephone. Use original batteries only. The guarantee does not cover any damage caused by incorrect use of batteries. Please dispose of any batteries in a responsible and environmentally friendly manner. www.doro.com... -
Page 6: Battery Charge Indicator
If during a call the handset is carried too far from the base unit a warning tone will be heard. Unless the handset is moved closer to the base unit within a few seconds the call will be lost. www.doro.com... -
Page 7: The Display
Indicates that a call is connected. Flashes when the phone rings. Hands free function. New number(s) in Caller ID log. Phone Book. Mute function. Charging indicator. Key Lock Internal Call Base unit indicator Light illuminated while charging; flashes during a call/registration. www.doro.com... -
Page 8: Operation
1. Press and hold until the display shows 2. To deactivate the key lock press and hold again. Calls can still be received even if the key lock is active. When the call is finished the handset returns to locked mode. www.doro.com... -
Page 9: Mute Button
The switchover between speaker and microphone is automatic and dependent on the sound level of the incoming call and the microphone respectively. It is therefore essential that there are no loud noises in the immediate vicinity of the telephone, as this will disrupt the speaker function. www.doro.com... -
Page 10: Memory
Dialling using speed dial memories 1. Press 2. Enter the required memory location, 3. Press the displayed number will now be dialled. Erasing all speed dial numbers 1. Press and hold until P is displayed. º 2. Press 3. Press 4. Press º www.doro.com... -
Page 11: Caller Identification
Messages Apart from showing phone numbers, the display can show: It is an International call or a call from a PBX (no information received). The list is empty. Time/date information not transmitted or received. www.doro.com... - Page 12 C for a few seconds while in standby mode. Please Note! In order for the network voice mail to operate, you must subscribe to this service and/or have it activated by your network operator. Contact your operator for more information. www.doro.com...
-
Page 13: Settings
5. Press to save. º The ringer can be switched on or off while the handset is not in use. To turn the ringer off press and hold until is displayed. Press and hold to turn ringer back on. www.doro.com... -
Page 14: Volume Control
4. Press to save. º Turning the function on/off To switch this function on or off simply repeat the following sequence. 1. Press and hold until P is displayed on the handset. º 2. Press 3. Press to save. º www.doro.com... -
Page 15: Recall Button Timing
An individual handset can be reset to the original factory default condition. 1. Press and hold until P is displayed on the handset. º 2. Press 3. Enter the units PIN number (0000 for this model). to save . 4. Press º www.doro.com... -
Page 16: Expanded System
Refer to the Registration chapter for more information. If you wish to use several handsets with one base unit, you should ensure that the base unit is centrally positioned in order to evenly divide the base units range among the handsets. www.doro.com... -
Page 17: Registering A New Handset
Any additional handset can easily be de-registered from a base unit. 1. Simultaneously press and hold until you hear a beep. 2. Enter the units PIN number (0000 for this model). 3. When HS is shown in the display, enter the handset number you wish to delete. www.doro.com... -
Page 18: Intercom Calls
5. To connect all three parties in a conference call, on the original handset press and hold until stops flashing in the handset display. Press on either handset to terminate the conference call, the other handset can then continue the conversation with the external party. www.doro.com... -
Page 19: Other
If that phone works, then it is likely that the equipment is faulty. If the telephone still does not work, contact Doro or the place of purchase. Don’t forget the receipt or copy of the invoice will be required for guarantee purposes. - Page 20 This telephone complies with applicable international safety requirements for exposure to radio waves. The SAR value of this telephone is no greater than 0.02 W/kg (measured over 10g of tissue). The maximum limit according to WHO is 2W/kg (measured over 10g of tissue). www.doro.com...
-
Page 21: Guarantee
(As a matter of precaution, we recommend disconnecting the telephone during a thunderstorm). This guarantee does not affect your statutory rights. AUSTRALIA NEW ZEALAND DORO Australia Pty Ltd Atlas Gentech (NZ) Limited PO Box 6760 Private Bag 14927 Baulkham Hills BC NSW 2153... -
Page 22: Notes For Operation In New Zealand
If a charge for local calls is unacceptable, the “DIAL“ button should NOT be used for local calls. Only the 7 digits of the local number should be dialled from your telephone. DO NOT dial the area code digit or the “0“ prefix. www.doro.com... - Page 24 English Version 1.0...
Need help?
Do you have a question about the 727 and is the answer not in the manual?
Questions and answers