Electrical Connection - Electrolux EHT 60418 Operating Instructions Manual

It is important to install the elbow correctly, with the shoulder on the end of the thread, fitted to the
hob connecting pipe.
Failure to ensure the correct assembly will cause leakage of gas.
IMPORTANT
Once installation is complete, check the perfectseal of every pipe fitting, using a soapy solution,
never a flame.

Electrical Connection

Any electrical work required to install this appliance should be carried out by a
qualified electrician or competent person, in accordance with the current regulations.
THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should these safety measures not be observed.
This appliance is designed to be connected to a 230 V
Before the appliance is connected:
1) check that the main fuse and the domestic installation can support the load (see the rating label);
2) check that the power supply is properly earthed in compliance with the current rules;
3) check the socket or the double pole switch used for the electrical connection can be easily reached
with the appliance built in the forniture unit. Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance rating plate. The rating plate is located on the
bottom of the hob. A copy is attached on the back cover of this book.
The appliance is supplied with a 3 core flexible supply cord incorporating a plug. Connect the plug to an
adequate socket.
Permanent connection
In the case of a permanent connection, it is necessary that you install a double pole switch between the
appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts
and of a type suitable for the required load in compliance with the current electric regulations.
The switch must not break the yellow and green earth cable at any point.
Ensure that the hob supply cord does not come into contact with surfaces with
temperatures higher than 50 deg. C.
electrolux 17
~
50Hz AC electrical supply.