Operation - Electrolux EHT 60418 Operating Instructions Manual

8 electrolux
INSTALLATION
Any gas installation must be carried out by qualified personnel, and in
accordance with existing rules and regulations.
The relevant instructions are to be found in the second section of this manual.
Please, ensure that, once the hob is installed, it is easily accessible for the
engineer in the event of a breakdown.
The manufacturer will not accept liability, should the above instructions or any
of the other safety instructions incorporated in this book be ignored.
WHEN THE HOB IS FIRST INSTALLED
Once the hob has been installed, it is important to remove any protective materials,
which were put on in the factory.

Operation

The symbols mean:
= no gas supply
= maximum gas supply
= minimum gas supply
Hob Burners
To light a burner:
Turn the relevant knob anticlockwise to maximum
position and push down the knob to ignite.
After lighting the flame, keep the knob pushed down
for about 5 seconds. This will allow the
"thermocouple" (Fig. 1 - lett. D) to be heated and
the safety device to be switched off, otherwise the
gas supply would be interrupted. Then, check the
flame is regular and adjust it as required.
If you cannot light the flame even after several attempts,
check the "cap" (Fig. 1 - lett. A) and "crown" (Fig. 1 -
lett. B) are in the correct position.
To put the flame out, turn the knob to the symbol .
In the absence of electricity, ignition can occur without the electrical device; in
this case approach the burner with a flame, push the relevant knob down and
turn it anti-clockwise until it reaches the"maximum" position.
When switching on the mains, after installation or a power cut, it is quite normal
for the spark generator to be activated automatically.
A - Burner cap
B - Burner crown
C - Ignition electrode
D - Thermocouple
Fig. 1