Clock setting function
To set the clock, enter the menu and select the "SET" page.
From this page, if you press switch (1, fig. 9) in position B
"▼" for 3 seconds, you enter clock setting mode.
On entering this function, the message "AM" flashes on
the display; if you press switch (1, fig. 9) in position B "▼",
the message "PM" flashes on the display; pressing switch
(1, fig. 9) in position B "▼" as second time returns you to
the previous step (if the time is 00:00, when you switch
from AM to PM the time 12:00 will appear);
if you press the switch (1, fig. 9) in position A "▲", you can
set the hours, which start flashing. Each time you press
the switch in position B "▼", the hours digit increases
cyclically in steps of 1 hour; hold the switch pressed down
in position B "▼" to scroll faster through the hours in steps
of 1 hour every second (when the switch is held pressed
continuously, the hour digits do not flash);
if you press switch (1, fig. 9) in position A "▲", you enter the
minutes setting mode and the minute digits will start
flashing. Each time you press the switch in position B "▼",
the minutes increase cyclically in steps of 1 minute; hold the
switch pressed in position B "▼" to scroll faster through the
minutes in steps of 1 minute every second. If the switch is
held pressed in position B "▼" for more than 5 seconds, the
minutes advance by 1 every 100 ms (when the switch is held
in position B "▼" continuously, the seconds do not flash).
if you press the switch in position A "▲", the system exits
setting mode and displays the newly set time.
Press B (for 3 secs.)
flash
flash
B
B
flash
A
flash
B
set
A
flash
B
set
A
E
A
A
A
fig. 27
35