Electrical Connection - Electrolux EWF10831 User Manual

This could be done by tying it to the tap
with a piece of string or attaching it to
the wall.
In a sink drain pipe branch. This
branch must be above the trap so that
the bend is at least 60 cm above the
ground.
Directly into a drain pipe at a height
of not less than 60 cm and not more
than 90 cm.
The end of the drain hose must always
be ventilated, i.e. the inside diameter of
the drain pipe must be larger than the
outside diameter of the drain hose.
The drain hose must not be kinked. Run
it along the floor; only the part near the
drainage point must be raised.
For the correct functioning of the
machine the drain hose must remain
hooked on the proper support piece
situated on the top part of back side
of the appliance.

Electrical Connection

This machine is designed to operate
on a 220-240 V, single-phase, 50 Hz
supply.
"An incorrect power supply may
void your warranty."
Check that your domestic electrical
installation can take the maximum load
required (2.0 kW), also taking into
account any other appliances in use.
Connect the machine to an earthed
socket.
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the above
safety precaution. Should the appliance
power supply cable need to be
replaced, this should be carried out by
our Service Centre.
Important!
When the appliance is installed the
power supply cable must be easily
accessible. If this appliance is supplied
from a cord extension set or electrical
portable outlet device, the cord
extension set or electrical portable
device must be positioned so that it is
not subject to splashing or ingress of
moisture.
installation electrolux 33
EN