32 electrolux installation
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets,
rugs etc. Check that the machine does
not touch the wall or cupboard units.
Carefully level by
screwing the
adjustable feet in
or out.
Never place cardboard, wood or similar
materials under the machine to
compensate for any unevenness in the
floor.
Water inlet
Connect the water inlet hose to a tap
with 3/4" BSP thread.
Use the hose supplied with the washing
machine. DO NOT USE OLD HOSES.
The other end of the inlet hose which
connects to the machine can be turned
in any direction.
Simply loosen the fitting, rotate the hose
and retighten the fitting, making sure
there are no water leaks.
The inlet hose must not be lengthened. If
it is too short and you do not wish to
move the tap, you will have to purchase
a new, longer hose specially designed
for this type of use.
Water drainage
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink using
the plastic hose guide supplied with
the machine.
In this case, make
sure the end
cannot come
unhooked when
the machine is
emptying.