Z Emergency Emptying; Cleaning The Filter In The Water Inlet - Electrolux SWISSLINE WA SL5M 102 Instructions For Use Manual

Emergency emptying
Emergency emptying is necessary if:
 The error message «CHECK DRAIN» appears.
 The pump is blocked by a foreign body (e.g. buttons,
paper clip, fluff) and the water cannot be pumped out.
Up to 20 litres can flow from a blocked pump.
Have a bucket ready.
Risk of scalding! Allow hot detergent solution to cool.
Emptying procedure
1. Switch off the mains power supply
2.
Open the maintenance flap by pressing on the recess.
3.
Take out the drainage hose, pull out the plug, let the
water run into a vessel. If necessary, repeat the procedure
several times.
4.
Unscrew the pump cover.
5. Remove foreign bodies and deposits of fluff. Clean the
pump interior. It must be possible to rotate the pump
impellers.
6.
Screw on the pump cover.
7.
Close the drainage hose.
8. Close the maintenance flap.
9.
Switch the mains power back on.
10.
Select a washing programme and as soon as the water
inlet stops, select programme end with the Quick Wash
button.
This procedure prevents detergent from flowing unused
into the drainage system at the next wash.
46

Cleaning the filter in the water inlet

The filter in the water inlet must be cleaned if no water
or insufficient water flows into the appliance when the
tap is turned on. The error message «CHECK WATER
SUPPLY» is displayed.
The filter are located in the threaded hose coupling on
the water tap and at the back of the machine.
Cleaning procedure
1.
Turn the water tap off.
2. Select a programme, start it and after approx. 20 seconds
select «Programme end» with the quick wash button.
As a result, the water pressure in the inlet hose can be
reduced.
3. Switch off the mains power supply.
4.
Unscrew the hose from the water tap and rinse out the
filter under running water.
5. Connect the hose again.
6.
Unscrew the hose only from the back of the machine.
7.
Pull out filter using a pair of flat­nose pliers. Clean and
reinsert it.
8.
Connect the hose again.
9.
Turn the water tap on and make sure that no water
escapes.
10.
Turn the water tap off.