Table of Contents
Advertisement
Setting the delay timer
3
With the TIME DELAY button you can post-
pone the start of a programme by 30 minutes
(30') to a maximum of 23 hours (23h).
1. Select programme.
2. Continue pressing the TIME DELAY button until the
desired start delay is displayed in the multi-display,
for example12h, if the start of the programme is to
be delayed by 12 hours. TIME DELAY light is lit.
3
If the display is showing 23h and you press the
button again, the time delay will be cancelled.
0' appears followed by the duration of the set
wash programme.
3. To activate the time delay, press the START/PAUSE
button. The remaining time till the programme start
is being shown (e. g. 12h, 11h, 10h, ... 30
Starting a programme
1. Check that the tap is turned on.
2. Press the START/PAUSE button. The programme
is started or starts after the time delay set has
elapsed.
3
If after the START/PAUSE button has been
pressed E40 flashes in the multi-display, the
END indicator flashes 4 times and at the same
time an acoustic signal sounds 4 times, the
door is not closed properly. Push the door
firmly closed and press the START/PAUSE
button again.
Programme progress
• The programme progress display shows the pro-
gramme step that is currently being performed.
• The multi-display indicates the estimated time re-
maining (in minutes) until the end of the pro-
gramme.
3
During the washing cycle the remaining time
may be increased or stay the same for a while
as the programme adjusts itself to different
conditions (e. g. type and quantity of laundry,
out of balance spin detection, special rinses,
etc.).
14
Interrupting a programme/
adding washing
Interrupting a programme
• A washing programme can be interrupted at any
time by pressing the START/PAUSE button. It is
then re-started by pressing the START/PAUSE but-
ton again.
• To stop the washing machine before the pro-
gramme has ended, turn the programme knob to
OFF. Important! Be careful if there is water in the
appliance!
Adding washing
It is possible to add washing, as long as the DOOR
light is lit green.
1.Press the START/PAUSE button. The door can be
'
opened.
etc.).
2.Shut the door and press the START/PAUSE button
again. The programme continues.
End of the wash cycle/
removing the washing
At the end of the programme, END lights up on the
programme progress display. The door can be
opened as soon as the DOOR indicator is lit green.
1.Open the loading door and remove the washing.
2.Turn the programme knob to OFF.
3.After washing, pull out the detergent drawer a little
to enable it to dry out. Keep the loading door very
slightly open so that the washing machine can air.
n
If
(RINSE HOLD) has been selected:
After the rinse hold, END lights up on the programme
progress display.
The water must first be drained:
– Either turn the programme knob to OFF, then to
DRAIN and press the START/PAUSE button (the
water is drained without spinning),
– or turn the programme knob to OFF and then to
SPIN. Change the spin speed if necessary and
press the START/PAUSE button (the water is
drained and the washing spun).
Overdosing
3
If the OVERDOSING indicator is lit, too much
detergent was used in the previous pro-
gramme. The next time you wash, observe the
dosing recommendations of the detergent
manufacturer and the load sizes.
Hide quick links:
Advertisement
Table of Contents
