Table of Contents
Advertisement
Take the switch spindle(s) of the built-in switchbox from the rear th-
rough the 13 mm dia. hole(s), attach white or black switch knobs as re-
quired and then secure the built-in switchbox from the rear to the
front of the cabinet.
For tiled working surfaces the joints must be completely filled with
6.
jointing material in the supporting zone for the grill plate.
The enclosed sealing tape must be attached to the underside of the grill
7.
plate.
Clean the working surface thoroughly in the seal supporting zone.
8.
Place grill plate in cut-out from above, centre and press down firmly. It
9.
requires no additional fixing owing to its own heavy weight.
Please do not apply any additional silicone sealing compound, since in
the event of removal of the grill plate both the seal and the working
surface could be damaged.
Important: If not fitted correctly it would be difficult to remove for
servicing and the grill plate and working surface could be damaged.
Warning: A recess base which can be dismantled must be fitted as con-
tact protection under the grill plate/built-in switchbox.
Removing the grill plate
1. Remove power supply from built-in switchbox/grill plate.
2. Place a clean spatula as protection on the working surface. Then care-
fully run a firmer chisel under the edge of the grill plate and raise.
3. For a new fitting it must be ensured that the old seal is removed com-
pletely cleanly and a new seal fitted (available from spare-parts sales).
Removing the built-in switchbox (for servicing)
1. Remove power supply from built-in switchbox and dismantle the recess
base.
2. Pull off switch knobs (if present remove CN front panel forwards).
Withdraw signal lamps from the lenses from the rear, release fixing
screws of built-in switchbox on the front of the cabinet from the rear,
draw the switchbox forwards carefully through the opening in the
recess base. Re-fitting is performed according to the fitting/installation
text.
Important: There are capillary tubes in the bunch of conductors bet-
ween the built-in switchbox and the grill plate. Do not bend sharply or
separate or the appliance will be destroyed.
19
Advertisement
Table of Contents
