Table of Contents
Advertisement
Fitting/installation in working surface: surface mounting
(coated, lined, Inox or stone)
When fitting in combustible material, the laws, ordinances, directives
and standards in force in the country of use as well as the local fire-
protection regulations are to be followed.
1. The lateral spacing of the working surface cut-out from a high-level
cabinet and the rear wall must be at least 50 mm.
2. Cut out working surface according to specified cut-out dimensions. The
tolerances must be observed. Seal the cut-out area of the working sur-
face against moisture with suitable varnish.
3. Holes for the built-in switchbox in the front of the cabinet with temp-
late as illustrated.
Panel thickness min. 16 mm, max. 22 mm.
4. Guide the built-in switchbox with the bundle of connecting conductors
from above through the working surfaces cut-out and from the rear to
the front of the cabinet.
Important: There are capillary tubes in the bunch of conductors bet-
ween the built-in switchbox and the grill plate. Do not bend sharply or
separate or the appliance will be destroyed!
5a. Assembly with CN-front panel (CN)
Guide the signal lamps from the rear through the 12 mm dia. holes in
the front of the cabinet (the 12 mm dia. holes can be enlarged to
15 mm to simplify assembly). Take the switch spindle(s) of the built-in
switchbox from the rear through the 13 mm dia. hole(s) and insert the
signal lamps in the signal lamp lenses mounted on the CN front panel
from the rear.
– TM 63600: insert signal lamp with red wires in the left-hand red lens.
– TM 43600: insert signal lamp with red wires in upper red lens.
Screw CN-front panel with screws to front of cabinet under switch kn-
obs. Attach switch knobes and then secure built-in switchbox in front
of cabinet from rear
5b. Assembly without CN-front panel (Vi)
Insert the signal lamp lenses supplied from the front in the 12 mm dia.
holes of the front of the cabinet.
– TM 63600: left-hand red lens.
– TM 43600: upper red lens.
Insert the signal lamps from the rear through the front of the cabinet
in the signal lamp lenses.
– TM 63600: insert signal lamp with red wires in the left-hand red lens.
– TM 43600: insert signal lamp with red wires in upper red lens.
18
Advertisement
Table of Contents
