Setting Digital Filter, Etc - Esoteric SA-60 Owner's Manual

PLAY AREA
1
When playback is stopped, press and hold the PLAY
AREA button for more than 2 seconds.
The unit enters setup mode, and "WORD> *** " appears on
the display. ( *** changes depending on your setting.)
In the following cases, the setup mode will be cancelled:
• Leave the unit idle for 10 seconds.
• Press and hold the PLAY AREA button for more than 2
seconds once again.
2 Repeatedly press the PLAY AREA button to select the
menu item to be changed.
3 Use the SKIP buttons (.//) to select the options
within the menu item.
4
Press and hold the PLAY AREA button for more than 2
seconds (or leave the unit idle for 10 seconds) to exit
the setup mode.
< Switching off the power without exiting the setup mode may
cause problems. Do not turn the unit off.
< Settings are stored even when power is turned off and the
unit is unplugged. If left unplugged for an extended period,
the settings may be lost.
20

Setting Digital Filter, etc.

Available menu item and options
WORD
/
< The WORD button of the remote control unit provides the
DF (digital filter)
DSD
(Normal display)
Turns on or off the word sync function.
same function (see page 18).
Selects the characteristic of the FIR digital filter. Choose
either "Wide" or "Narrow".
Select "Normal (factory default)" to output DSD after
processing and "Direct" to output the audio signal without
running it through the processor.
The analog level in the Direct mode is 3 dB lower than in the
Normal mode.
Exit the setting mode.