Changing The Network Encryption Key, One Unit At A Time - NETGEAR XAV1004 User Manual

1. Open the XAV1004 Powerline Utility and select the Security tab.
Figure 3-1
2. Select the local device.
3. For each remote device, enter its password (printed on the product label), and then select it.
4. Click the Use Default (Public Network) button, and then click the Set Selected Devices
button.
5. Select the Main tab, and check that the utility detects all the Powerline AV Ethernet Adapters
in your Powerline network.
If the utility detects all your Powerline devices, you can specify a new network encryption key as
described in "Changing the Network Encryption Key" in Chapter
them all, see the following section,

Changing the Network Encryption Key, One Unit at a Time

If the utility does not detect all the devices, you must connect your computer to each Powerline
device and set up the network encryption key one at a time, as follows:
1. Select the Security tab in the XAV1004 Configuration Utility.
2. Type the network encryption key that you want to assign in the Apply the Encryption Key
setting field, and then click Set Selected Devices.
3. Select the Main tab, and then click Scan. Check that the utility detects all the devices that have
been individually set to the same network encryption key.
Troubleshooting
XAV1004 Powerline AV Ethernet Adapter User Guide
"Changing the Network Encryption Key, One Unit at a
v1.1, September 2009
2. If the utility does not detect
Time.
3-3