Xav1004 Front View - NETGEAR XAV1004 User Manual

XAV1004 Front View

The front view of the XAV1004 is shown in the following illustration:
Figure 1-2
The following table describes the status lights (LEDs) on the front of the XAV1004.
Table 1-1. XAV1004 LEDs
Item Description
Ethernet LED • Solid green. The Ethernet port is linked, but there is no activity.
• Blinking green. There is traffic between an Ethernet port and the Powerline
• Off. There is no Ethernet connection.
Powerline LED • Solid. The adapter is connected to a Powerline network.
• Fast blinking. The adapter is sending or receiving data.
• Off. The adapter has not found any other compatible Powerline devices using the
The Pick A Plug feature shows by the color of the LED the speed of the Powerline
link for the electrical outlet where the device is connected:
• Green. The link rate is faster than 80 Mbps.
• Amber. The link rate is between 50 Mbps and 80 Mbps.
• Red. The link rate is slower than 50 Mbps.
If the LED is not green, try another outlet. You may get a better link rate, and the LED
will turn green.
Power LED • Solid green. The electrical power is on.
• Fast blinking. The adapter is setting itself up after the reset or Security button was
• Slow blinking. The adapter goes into power saving mode if no Ethernet device is
• Off. There is no electrical power.
Installation and Basic Configuration
XAV1004 Powerline AV Ethernet Adapter User Guide
Powerline Power
Ethernet
LED
LED
("Pick A Plug")
network.
same Powerline network encryption key.
pressed.
connected.
v1.1, September 2009
LED
1-3