Editing A Single Tape - Go-Video GV2020 Owner's Manual

Editing a
Single Tape
1
2
POWER
6 7
COPY
TV/VCR TAPE
1
STOP/EJECT
CTR RESET
UP
PLAY
PREV NEXT
DOWN REW FWD
MENU SAVE ESC SOURCE
DECK 1 DECK 2
1 2
POWER
6 7
COPY
TAPE
TV/VCR
1
RESET STOP/EJECT
CTR
UP
PLAY
PREV NEXT
DOWN REW FWD
MENU ESC SOURCE
SAVE
DECK 1 DECK 2
16
To simplify editing, first turn off Auto Play (see page 23). This prevents
tapes from playing each time they are inserted.
You may also find it easier to edit when the On-Screen Display is on your
TV screen. The OSD shows you the status and Tape Counter of both decks
at all times. Press DSP to see the OSD. The On-Screen Display lettering will
not be recorded on your video tape.
Follow these simple instructions to edit out scenes from a single tape.
Insert a blank tape into Deck 2 and the prerecorded tape into Deck 1.
Press the Copy Tape™ button.
Just before the unwanted scene begins:
3 4 5
Press the Deck 2 Pause button to pause the recording.
DSP
8 9 0
LCV CH
REC will blink on the Front Panel Display.
2
STOP/EJECT
Avoid leaving the deck in record pause for more than 3 minutes. Your
PLAY
VCR-2 will Auto Stop after 5 minutes in record pause to prevent exces-
REW FWD
PAUSE PAUSE
sive tape wear.
REC SOURCE REC
TV
If you desire, you can press the Deck 1 Fast Forward button to Picture
VIEW
TUNER AV•IN
Scan to the end of the unwanted segment. Press the Deck 1 Play button
to end Picture Scan.
When the unwanted scene ends:
Press the Deck 2 Record button to continue recording.
Repeat steps
Press the Copy Tape button to end editing.
The audio track recording may continue for a few seconds after the
video track ends. Practice and experimentation will refine your editing
skills and help you to choose the best edit points to improve your edited
tapes.
When performing more advanced editing, it may be necessary to adjust the
position of your record tape to record over unwanted sections.
3 4 5 During an edit session, follow these instructions to adjust the position of
DSP
your record tape.
9 0
8
LCV CH
2
Press the Deck 2 Stop button. This will stop both decks.
STOP/EJECT
PLAY
Press the Deck 2 Play button and then use Rewind to locate the point
where you want to resume recording. Play the tape two seconds past
PAUSE REW FWD PAUSE
this point and press Pause.
REC SOURCE REC
TV
VIEW
Press the Deck 2 Record button. Deck 2 will enter record pause.
TUNER AV•IN
Press the Deck 1 Play button and you may continue editing at step
above. Copy Tape will resume when you continue recording.
and until all the unwanted scenes have been removed.