ProForm 870e User Manual page 7

4
33
35
View from the Front
Next, locate the Reed Switch (4). Turn the arms of the
Crank (22) until the Magnet (33) is aligned with the
Reed Switch. Loosen but do not remove the indicated
Screw (35). Slide the Reed Switch slightly closer to or
away from the Magnet. Retighten the Screw. Turn the
Crank for a moment. Repeat until the console displays
correct feedback. When the Reed Switch is correctly
adjusted, reattach the left side shield, flywheel cover
and left pedal.
22
HOW TO ADJUST THE DRIVE BELT
The exercise cycle features a Drive Belt (1) that must
be kept properly adjusted. If the Drive Belt slips as you
pedal, it should be adjusted. To do this, the left side
shield and the flywheel cover must be removed. Refer
to the instructions on page 12 and remove these parts.
View from the Back
Next, locate the Drive Belt (1). To tighten the Drive
Belt, turn the 3/8" Locknut (47) slightly; be careful not
to overtighten the Drive Belt. When the Drive Belt is
properly adjusted, reattach the left side shield, flywheel
cover and left pedal.
13
1
1
45