ProForm 870e User Manual page 10

4. Identify the Left Pedal (20); there is an "L" on the
Left Pedal for identification. Using an adjustable
wrench, tighten the Left Pedal counterclockwise into
the left arm of the Crank (22).
Tighten the Right Pedal (not shown) clockwise into
the right arm of the Crank (22).
5. Hold the Handlebar Post (19) near the Frame (13)
as shown. Feed the Resistance Cable (6) and the
Reed Switch Wire (4) into the Frame, and then slide
the Handlebar Post into the Frame. Be careful not
to pinch the Resistance Cable or the Reed
Switch Wire. Attach the Handlebar Post with three
M10 x 22mm Button Head Bolts (55) and three M10
Lock Washers (61).
The Console (5) requires two 1.5V batteries (not
included). Alkaline batteries are recommended.
Refer to the inset drawing. Locate the battery door
on the back of the Console. Slide the battery door to
the left and open it as shown. Press two batteries
into the battery clip, with the negative (–) ends of the
batteries touching the springs. Close the battery
door and slide it to the right.
6. Attach the Handlebar (18) to the Handlebar Post
(19) with two M10 x 22mm Button Head Bolts (55)
and two M10 Lock Washers (61).
4
20
5
4
6
61
55
6
55
18
6
22
5
19
55
Battery
Door
61
55
Batteries
13
Battery Clip
61
19
5