ProForm 762 Ekg Bike User Manual page 8

INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (see page 18), follow the steps below to install the receiver and
the short jumper wire included with the chest pulse sensor.
1. Remove the four indicated screws from the back of the
Console (16). Lift off the front of the Console.
2. Plug the short jumper wire (A) into the indicated jack on
the Console (16). Connect the other end of the short
jumper wire to the wire on the receiver (B). Note:
Discard any other wires included with the chest
pulse sensor.
Next, peel the paper off the adhesive pad on the back
of the receiver (B). Orient the receiver as shown, and
press it onto the Console (16) in the indicated location.
See step 1 above. Reattach the front of the Console
(16) with the four screws. Make sure that no wires
are pinched.
1
16
Short
Screws
Long
Screws
2
B
16
8
Lift
Here
Cylinder
A
Jack