ProForm 762 Ekg Bike User Manual page 6

5. Attach the Seat (12) to the Seat Frame (6) with three
M6 x 16mm Screws (87).
6. Attach the Backrest (10) to the Backrest Frame (5)
with two M6 x 16mm Screws (87), an M6 x 50mm
Screw (69), and an M6 Flat Washer (71).
Attach the Headrest (11) to the Backrest Frame (5)
with two M6 x 50mm Screws (69) and two M6 Flat
Washers (71).
7. Whilst another person holds the Upright (13) in the
position shown, connect the Upper Wire Harness (35)
to the Lower Wire Harness (36). Carefully pull the
upper end of the Upper Wire Harness to remove
any slack from the Wire Harnesses.
Turn the Knob (not shown) on the right side of the
Frame (1) counterclockwise two or three turns to loosen
it. Next, pull the Knob, insert the Upright (13) into the
Frame, and then release the Knob. Move the Upright
up and down slightly until it locks into position. Be
careful to avoid pinching the Wire Harnesses (35,
36). Tighten the indicated M6 x 25.4mm Button Screw
(79) into the slot in the side of the Upright.
8. Connect the wire harness on the Handgrip Pulse
Sensor (15) to the indicated wire harness on the
Console (16). Insert both wire harnesses into the open-
ing in the bottom of the Console. Then, insert the metal
tube on the Handgrip Pulse Sensor into the opening in
the bottom of the Console. Be careful not to pinch the
wire harnesses.
Snap the bookrack onto the Console (16) where shown.
See the inset drawing. Tighten an M4 x 16mm Screw
(73) into the indicated bracket on the Console (16) and
into the metal tube on the Handgrip Pulse Sensor (15).
5
12
6
6
11
10
7
Be careful not to
pinch the Wire
Harnesses (35, 36).
8
Bookrack
16
73
6
87
87
5
71
71
87
Upper End
13
Slot
35
36
1
79
16
73
Metal
Tube
15
69
69
Knob
15