ProForm 710 Ekg Exercise Bike User Manual page 5

2. While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (14) to the Frame with two
M10 x 73mm Button Screws (33) and two M10 Split
Washers (34).
3. While another person holds the Upright (3) near the
Frame (1), connect the Upper Wire Harness (32) to the
Lower Wire Harness (31).
Gently pull the upper end of the Upper Wire Harness
(32) to remove the slack, and slide the Upright (3) onto
the Frame (1). Be careful to avoid pinching the Wire
Harnesses. Attach the Upright with three M10 x 20mm
Button Screws (35) and three M10 Split Washers (34).
4. The Console (6) requires four "AA" batteries; alkaline
batteries are recommended. Press the tab on the bat-
tery cover and remove the battery cover. Insert four
batteries into the console; make sure that the batter-
ies are oriented as shown. Then, reattach the battery
cover.
Note: The Console (6) can be operated with an
optional power supply instead of batteries. To pur-
chase a power supply, call the telephone number
on the front cover of this manual. Plug one end of
the power supply into the jack on the console. Plug
the other end of the power supply into an appropriate
outlet that is properly installed in accordance with all
local codes and ordinances.
2
3
3
35 34
1
4
5
14
1
34
34
33
Be careful to avoid
pinching the Wire
Harnesses (31, 32)
35
34
32
31
Battery
Cover
Batteries
6