Maintenance And Troubleshooting - ProForm 710 Ekg Exercise Bike User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and properly tighten all parts of the exercise
cycle regularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild soap. Important: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
PULSE SENSOR TROUBLESHOOTING
For optimal performance of the pulse sensor, keep the
metal contacts clean. Clean the contacts with a soft
cloth—never use alcohol, abrasives, or chemicals.
Avoid moving your hands while using the pulse sen-
sor. Excessive movement may interfere with heart
rate readings. Do not hold the metal contacts too
tightly; doing so may interfere with heart rate read-
ings. For the most accurate heart rate reading, hold
the metal contacts for about 15 seconds.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the left pedal and the left side shield must be
removed.
Using an adjustable wrench, turn the left pedal clock-
wise and remove the left pedal.
Remove the screws from the left side shield. Note:
There are two different sizes of screws in the left side
shield. Be sure to note the location of each screw.
Then, carefully pry the left side shield away from the
exercise cycle.
Next, locate
the Reed
Switch (21).
Turn the Left
Crank Arm
(42) until the
Magnet (16) is 53
aligned with
the Reed
Switch.
Loosen, but
do not
remove, the
indicated M5 x 12mm Screw (53). Slide the Reed
Switch slightly closer to or away from the Magnet, and
then retighten the Screw. Turn the Crank Arm for a
moment. Repeat until the console displays correct
feedback.
When the Reed Switch is correctly adjusted, reattach
the left side shield and the left pedal.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. To replace the batteries, see
assembly step 4 on page 5.
HOW TO LEVEL THE EXERCISE CYCLE
If the exercise cycle rocks slightly on your floor, turn
one or both of the leveling feet under the rear
stabilizer.
13
21
16
42