Operating instructions
Burner locations
11
Burner ignition &
control
13
1
3
6
1. Medium burner
2. Medium burner
3. Wok burner
Depress control knob and turn anti-clockwise to "High
flame"position. Hold the knob down for a few seconds
until the flame ignites. Keep control knob depressed for
a few seconds to activate the flame failure device. If
ignition fails, depress knob again and wait for ignition.
Turn anti-clockwise to set the flame to the desired
intensity.
If ignition fails depress knob and try again. If flame is
not established in 15 seconds release the control
knob and open a door and wait 1 minute before
attempting a new ignition procedure.
All burners are fitted with a flame failure device which
shuts off the gas supply if the flame extinguishes for
any reason. To re-ignite, wait 30 seconds for any unburnt
gas to disperse before repeating the ignition procedure
described above.
To turn off the gas supply to a burner turn the control
knob clockwise to the "OFF" position. (Refer Fig.
The control knob is used to adjust the flame of the gas
burner.
"Low flame" graphic= lowest output
"High flame" graphic= higest output
If the ignition sparkers are dirty, this makes the burners
harder to light, so you should keep them as clean
as possible. Clean them using a small brush and
remember that the ignition sparkers must be treated
very gently.
5
4
4
12
4. Small burner
5. Rapid burner
6. Control Knobs
12
3
5
1
6
Burner
Position
Graphic
2
1 2
)