Table of Contents
Advertisement
Be careful when you connect the water inlet hose:
• Do not put the water inlet hose or the safety valve in water.
• If the water inlet hose or the safety valve is damaged, immediately disconnect the mains
plug from the mains socket.
• Only let the Service Force Centre replace the water inlet hose with safety valve.
WARNING!
Dangerous voltage
Water drain hose
1. Connect the water drain hose to the sink spigot and attach it under the work surface.
This prevents that the waste water from the sink goes back into the appliance.
2. Connect the water drain hose to a stand pipe with vent-hole (minimum internal di-
ameter 4 cm).
The waste connection must be at a maximum
height of 60 cm from the bottom of the dish-
washer.
Make sure that the drain hose is not bent or
squashed to prevent that the water drains does not
drain correctly.
Remove the sink plug when the appliance drains
the water to prevent that the water goes back into
the appliance.
The total length of the drain hose, extension in-
cluded, must not be longer than 4 m. The internal
diameter must not be smaller than the diameter
of the hose
Water connection
25
Advertisement
Table of Contents
