Adjustment Of The Display (Direct); Returning The Screen Adjustment To The Factory Default Settings (Normal) - NEC 42/50PD1 User Manual

Adjustment of the Display (Direct)

Press the buttons of the remote control to make direct
adjustments and settings. A press of the desired button will
show the adjustment display. The adjustment condition is
stored in memory even after the power is switched off.
Preparation: Select the input screen (VIDEO, RGB1,
RGB2, RGB3) that is to be adjusted, then input the signal
of the connected equipment.
Adjustment of the Screen
The adjustment of screen size is made easier when a
geometric shape such as a square is displayed.
Press the button to show the adjustment display. The display
will go off about 3 seconds after your finger is released
from the button.
Adjustment of the screen display position
POSITION / CONTROL
Move up
Move left
Adjustment display of the up/down position
V-POSITION
MOVE DOWN
Adjustment display of the left/right position
H-POSITION
MOVE LEFT
Move right
Move down
MOVE UP
MOVE RIGHT
Returning the Screen Adjustment
to the Factor y Default Settings
(NORMAL)
The display position (POSITION) will return to the factory
default setting. At this time the following settings of the
menu control will also simultaneously return to the factory
default settings: auto picture, picture adjust, fine picture,
H/V-POSITION 1, H/V-POSITION 2, H-WIDTH (Multiple
Screens only), V-HEIGHT (Multiple Screens only), and
OSM location.
1. Press the RASTER NORMAL button
The verification sub menu is displayed.
WARNING
ABOUT TO PRESET
PRESS:
'PROCEED' TO RESET
'EXIT' TO CANCEL
2. A press of the PROCEED button will reset the
adjustment.
To cancel the reset, press the EXIT button.
PROCEED
* Use the RASTER NORMAL button. A press of the
VISUAL NORMAL button will not return the screen
adjustment to the factory default setting.
* A press of the NORMAL button during the on-screen
display will return only the display item to the factory
default setting.
H-POSITION 1,2 and V-POSITION 1,2 are not avail-
*
able at the time of RGB input when AUTO PICTURE is
turned on.
To adjust H-POSITION 1,2 and V-POSITION 1,2 at the
time of RGB input, turn off AUTO PICTURE.
23
RASTER
NORMAL
RASTER