Starting The Programme; Changing Programme; Putting In Extra Items Or Taking Items Out Before End Of Programme - AEG Electrolux 8050 TW Electronic User Manual

The child safety device is not deactivated once the programme comes to an end.
If you want to set a new programme, you must first deactivate the child safety
device.

Starting the programme

Press the START PAUSE button. The pro-
gramme is started.
The programme progress is shown in LCD by
appropriate set of icons. From left to the right,
from IRON DRY
depends on the drying cycle chosen. E. g. in
case of CUPBOARD programme the following
status icons are visible:
Current cycle progress is marked by flashing dash under status icon. When appro-
priate part of drying cycle is accomplished dash becomes steady and appears
flashing under next status icon.

Changing programme

To change a programme which has been selected by mistake once the programme
has started, first turn the programme selector to OFF AUS and then reset the pro-
gramme.
The programme can no longer be changed directly once the programme has started.
If nevertheless there is an attempt to change the programme on the programme
knob, the programme progress display and the maintenance indicators flash. If an
option button (excluding the BUZZER SIGNAL button) is pressed, Err appears in the
multidisplay. The drying programme is not however affected by this (laundry pro-
tection).

Putting in extra items or taking items out before end of programme

1. Open loading door.
WARNING!
Laundry and drum can become hot. Risk of burns!
2. Load or remove laundry items.
3. Close loading securely. Lock must audibly lock.
to ANTI-CREASE icon
.
Daily use 19