AEG Electrolux 8050 TW Electronic User Manual page 28

28 What to do if ...
Displayed programme
time changes
erratically or stays un-
changed for a long
time.
Programme inactive,
empty water tank
icon is on.
Drying cycle ends
shortly after pro-
gramme starts.
Drying cycle lasts an
unusually long time.
Note: After around 5
hours the drying cycle
ends automatically
(see „Drying cycle
complete ").
Defective light bulb.
Programme time is corrected
automatically depending on type
and volume of laundry and level of
dampness.
Condensate tank is full.
Not enough washing loaded or
washing loaded is too dry for selec-
ted programme.
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Laundry insufficiently spun.
Particularly high room tempera-
ture. Temporary switching off of
the compressor to avoid overload.
Replace light bulb (see next sec-
tion).
Automatic process; this is not a ma-
chine fault.
Empty condensate tank, then start
programme with START PAUSE but-
ton.
Select time programme or higher
drying level (e.g. INTENSIVE DRY
STARKTROCKEN instead of CUP-
BOARD DRY SCHRANKTROCKEN ).
Clean lint filter.
Clean fluff filter.
Reduce load volume.
Laundry must be adequately spun.
Automatic process, there is no fault
with the appliance. If possible,
lower the room temperature.