Machine Settings - AEG Electrolux 8050 TW Electronic User Manual

30

Machine settings

Machine settings
Setting
SIGNAL
BUZZER
off
Water hardness
Water contains, a variable
quantity of limestone and
mineral salts of which quanti-
ties vary according to
geographical locations thus
varying its conductivity values.
Relevant variations of the
conductivity of the water com-
pared to those prefixed by the
factory could slightly influence
the residual humidity of the
laundry at the end of the cycle.
Your dryer allows you to regu-
late the sensitivity of the drying
sensor based on conductivity
values of the water.
Emptying water tank - warn-
ing message permanent off
When using an external drain
for the condensed water.
permanent 1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS TROCKENGRAD and RPM
U/MIN buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off. You can use BUZZER
SIGNAL button to activate or deactivate sound but machine
does not memorize your selection.
1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS TROCKENGRAD and TIME
ZEITWAHL buttons and hold down for approx. 5 seconds. The
current setting is on the display:
–
–
–
3. Press the START PAUSE button sequentially until you set de-
sired level.
4. To memorize setting press simultaneously the DRYNESS
TROCKENGRAD and TIME ZEITWAHL. buttons or turn knob to
OFF AUS position
1. Turn the programme selector to any programme.
2. Press simultaneously the RPM U/MIN and TIME ZEITWAHL
buttons and hold down for approx. 5 seconds.
The current setting is on the display:
– warning
– warning
By default the warning message is switched on and displayed
always at the end of the drying cycle or during the cycle if the
water container is full.
Implementation
low conductivity <300 micro S/cm
medium conductivity 300-600 micro S/cm
high conductivity >600 micro S/cm
icon and
icon and
switched on
- warning message is off
- warning message is