BMW E65 Installation Instructions Manual page 24

8. To install the monitor
1
AP
1
H
AP
© BMW AG, München
AP
F
6
F1
F2
6
G 1
AT
6
AA
AL
AP
AA1
6
Secure the adhesive marking (1) that you pre-
1
viously fitted on the seat wiring harness F to the
seat backrest (2) as shown using a cable tie AP.
2
667 Z
Thread branches F1 and F2 through the front
seat rear panel (1).
Install the front seat rear panel (1) as described in
TIS RA 52 15 198.
762 Z
Unscrew the tooth washer (1) and hexagonal nut (2)
from the auxiliary cable G and headphone cable H.
2
Insert the auxiliary cable G into the front monitor
trim AT on the left and secure it with a toothed
washer (1) and hexagonal nut (2).
Insert the headphone cable H into the front
monitor trim AT on the right and secure it with a
toothed washer (1) and hexagonal nut (2).
67 Z
Insert grommets AL into the monitor AA.
Thread headphone connector AA1 for the
monitor AA through the top grommet AL.
Insert cable ties AP into the existing holes.
661 Z
01 29 0 406 372
12.2005 (Z/Z) 24