ProForm 605 Hr Elliptical User Manual page 6

5. The Console (5) requires four 1.5V "D" batteries; alka-
line batteries are recommended. See the inset draw-
ing. Press the tab on the battery cover, and and
remove it. Insert four batteries into the battery com-
partment. Make sure that the batteries are turned
as shown by the diagram in the battery compart-
ment. Reattach the battery cover.
Whilst another person holds the Console (5) in the
position shown, connect the wire harness on the
Console to the Upper Wire Harness (86). Insert the
excess wire harness into the Upright (2). Next, attach
the Console to the Upright with three M10 x 27mm
Button Screws (71) and three M10 Split Washers (70).
Be careful to avoid pinching the wire harnesses.
Snap the bookrack onto the Console (5).
6. Identify the Left Handlebar (9), which is marked with a
sticker. Insert the Left Handlebar into one of the
Handlebar Legs (79); make sure that the Handlebar
Leg is turned so the hexagonal holes are on the
indicated side. Attach the Left Handlebar to the
Handlebar Leg with two M8 x 45mm Button Bolts (50)
and two M8 Nylon Locknuts (46). Make sure that the
Nylon Locknuts are inside of the hexagonal holes.
Do not fully tighten the Button Bolts yet.
Apply a generous amount of the included grease to the
Pivot Axle (93) and to the two M8.5 Washers (53). Next,
insert the Pivot Axle into the Upright (2) and centre it.
Reapply grease to both ends of the Pivot Axle.
Slide a Handlebar Spacer (25) onto the short tube on the
Left Handlebar (9), and rotate the Handlebar Spacer so
the small arrow is pointing toward the floor. Next, slide
the Left Handlebar onto the left end of the Pivot Axle
(93). Finger tighten an M8 x 25mm Patch Screw (22)
with an M8.5 Washer (53) and a Wave Washer (94) into
the end of the Pivot Axle. Then, press the small tabs on
a Handlebar Cap (23) into the Handlebar Spacer.
Assemble the Right Handlebar (not shown) and the other
Handlebar Leg (not shown) in the same way. Then,
tighten both M8 x 25mm Patch Screws (22).
7. Hold the lower end of the left Handlebar Leg (79) inside
of the left Front Spring Bracket (17). Apply a generous
amount of grease to an M10 x 78mm Button Bolt (27).
Attach the left Handlebar Leg to the left Front Spring
Bracket (17) with the Button Bolt, two M10 Washers
(38), and an M10 Nylon Locknut (29). Do not over-
tighten the Nylon Locknut; the left Handlebar Leg
must be able to pivot freely.
Attach the right Handlebar Leg (79) to the right Front
Spring Bracket (17) in the same way.
5
Tab
Battery
Cover
Batteries
6
9
53
22
95
23
50
7
79
38
38
27
17
Grease
6
Bookrack
5
Wire
Harness
86
71
70
71
5
Grease
93
2
25
Arrow
46
Hexagonal
Holes
79
79
29
2
71
70
17