NordicTrack T15.0 Treadmill User Manual page 12

11. With the help of a second person, hold the con-
sole assembly near the Left Handrail (88).
Connect the Upright Wire (81) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Then, remove the wire tie from
the Upright Wire.
Connect the ground wire from the console
assembly to the Console Ground Wire (105) and
insert the wires into the hole in the console
assembly.
12. Set the console assembly on the Left and Right
Handrails (88, 87). Be careful not to pinch
any wires. Insert the excess Upright Wire (not
shown) into the Left Handrail.
Attach the console assembly with eight #8 x 1/2"
Screws (1) (only one side is shown). Start all
eight Screws, and then tighten them.
Attach two Console Clamps (106) to the console
assembly with four #8 x 1" Screws (25).
See step 7. Fully tighten the four 5/16" x 1"
Screws (5) and the two 5/16" x 1 1/2" Bolts (4).
11
Hole
Ground
105
Wire
Console
Assembly
Console
Wire
81
12
106
25
1
87
12
Console
Wire
81
Wire
Tie
88
Console
Assembly
106
25
1
1
88