Assembling The Rear Wheel; Adjusting The Rear Wheel Static Balance; Installing The Rear Wheel (Disc) - Yamaha YZF-R125 Service Manual

YamahaR125.COM
M MMM M MMM M M MMM M
a. Remove the self-locking nuts and the rear
wheel sprocket.
b. Clean the rear wheel drive hub with a clean
cloth, especially the surfaces that contact the
sprocket.
c. Install the new rear wheel sprocket.
Rear wheel sprocket self-locking
nut
43 Nm (4.3 m·kg, 31 ft·lb)
NOTE:
Tighten the self-locking nuts in stages and in a
crisscross pattern.
L LLL L LLL L L LLL L
EAS22140

ASSEMBLING THE REAR WHEEL

1. Install:
• Wheel bearings New
• Oil seals New
Refer to "ASSEMBLING THE FRONT
WHEEL" on page 4-9.
EAS22150
ADJUSTING THE REAR WHEEL STATIC
BALANCE
NOTE:
• After replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub installed.
1. Adjust:
• Rear wheel static balance
Refer to "ADJUSTING THE FRONT WHEEL
STATIC BALANCE" on page 4-9.
EAS22160

INSTALLING THE REAR WHEEL (DISC)

1. Install:
• Rear brake disc
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
MMM
NOTE:
Tighten the brake disc bolts in stages and in a
crisscross pattern.
2. Check:
• Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-33.
3. Lubricate:
• Rear wheel axle
• Contact surface of rear wheel hub and rear
wheel
LLL
• Wheel bearings
• Oil seal lips
4. Adjust:
• Drive chain slack
Refer to "ADJUSTING THE DRIVE CHAIN
SLACK" on page 3-21.
4-16
REAR WHEEL
Rear brake disc bolt
18 Nm (1.8 m·kg, 13 ft·lb)
LOCTITE®
Recommended lubricant
Lithium-soap-based grease
Drive chain slack
30.0–40.0 mm (1.18–1.57 in)