Removing The Primary Drive Gear And Balancer Gears; Checking The Balancer Gears And Primary Drive Gear; Installing The Primary Drive Gear And Balancer Gears - Yamaha YZF-R125 Service Manual

YamahaR125.COM
EAS5D71018
REMOVING THE PRIMARY DRIVE GEAR
AND BALANCER GEARS
1. Loosen:
• Primary drive gear nut "1"
NOTE:
Place the aluminum plate "a" between the bal-
ancer drive gear "2" and the balancer driven
gear "3", and then loosen the primary drive gear
nut.
2
1
2. Straighten the lock washer tab.
3. Loosen:
• Balancer driven gear nut "1"
NOTE:
Place the aluminum plate "a" between the bal-
ancer drive gear "2" the and the balancer driven
gear "3", and then loosen the balancer driven
gear nut.
2
EAS5D71019
CHECKING THE BALANCER GEARS AND
PRIMARY DRIVE GEAR
1. Check:
• Balancer drive gear
• Balancer driven gear
Cracks/damage/wear → Replace.
2. Check:
• Primary drive gear
Refer to "CHECKING THE PRIMARY DRIVE
GEAR" on page 5-43.
3
a
a
1
3
5-54
BALANCER GEAR
EAS5D71021
INSTALLING THE PRIMARY DRIVE GEAR
AND BALANCER GEARS
1. Install:
• Balancer driven gear "1"
• Lock washer New
• Balancer drive gear "2"
• Primary drive gear
• Washer "3"
• Balancer driven gear nut
• Primary drive gear nut
NOTE:
• Align the punch mark "a" in the balancer drive
gear "2" with the punch mark "b" in the balancer
driven gear "1".
• Be sure to install the washer so that its sharp
edge "c" is facing the primary drive gear.
2
a
2. Tighten:
• Balancer driven gear nut "1"
• Primary drive gear nut "2"
Balancer driven gear nut
50 Nm (5.0 m·kg, 36 ft·lb)
Primary drive gear nut
60 Nm (6.0 m·kg, 43 ft·lb)
NOTE:
• Place the aluminum plate "a" between the bal-
ancer drive gear "3" and the balancer driven
gear "4", and then tighten the balancer driven
gear nut.
b
3
c
1