Time Settings - Buffalo WZR-HP-AG300H User Manual

Setup -> Basic Setup
 WAN Setup
o Choose "Disabled" for "Connection Type" (this will be set
automatically).
 Network Setup
o Enter the desired LAN-side IP address for the router into "Router
IP".
o "Disable" "DHCP Server".
 Time Settings
o Choose your time zone.
 Click "Save".
Wireless -> Basic Settings
 Enter your country in "Regulatory Domain".
 In the "Antenna Gain" field, please enter the gain of your
AirStation's antenna. The firmware will adjust the transmit power
automatically to meet regulatory requirements. Please note that the
use of a long extension cable for your antenna will reduce the
usable antenna gain.
 Configure "Wireless Mode" to "Client Bridge".
 Set "Wireless Network Mode" to match the access point you want to
connect to.
 Enter the network name (SSID) of the AP you want to connect to.
 Click "Save".
Wireless -> Wireless Security
 Configure security to match the security settings of the access
point you want to connect to.
 Click "Apply Settings".
After the router reboots, please confirm that it has connected to the
access point. If there is a DHCP server available on the access point
- 22 -