Chapter 4 - Configuration; Accessing The Web-Based Configuration Interface - Buffalo WZR-HP-AG300H User Manual

Chapter 4 - Configuration

The web-based configuration tool lets you change advanced settings for the AirStation. Don't
change these settings unless you know what you're doing.

Accessing the Web-based Configuration Interface

To configure the AirStation's advanced settings manually, log in to the web-based configuration
interface as shown below.
1
Launch a web browser.
2
Note: · The AirStation's default LAN-side IP address depends on the position of the mode switch.
In router mode: 192.168.11.1
In bridge mode: 192.168.11.100
Note: If the router switch is set to auto and the unit is in bridge mode, then the AirStation's IP
· If you changed the IP address of the AirStation, then use the new IP address.
3
WZR-HP-AG300H User Manual
address was assigned by an external DHCP server.
Enter the AirStation's LAN-side IP address in the
address field and press the Enter key.
When this screen appears, enter "root"
(in lower case) for the username and the
password that you set during initial setup.
Click [OK].
Note: · By default, the password is blank (not set).
· If you forget your password, hold down the
reset button (page 12) to initialize all settings.
The password will then be blank. Note that
all other settings will also revert to their
default values.
24