Cannot Connect To The Network Wirelessly; You Forgot Airstation's Ssid, Encryption Key, Or Password; The Link Speed Is Slower Than 300 Mbps (Maximum Link Speed Is Only 130 Mbps) - Buffalo WZR-HP-AG300H User Manual

Chapter 6 Trouble Shooting

Cannot connect to the network wirelessly.

• Configure your wireless client with the same SSID, encryption type, and encryption key as set
on the AirStation.
The factory defaults are:
SSID -
Encryption Type -
Encryption Key -
Note: Encryption is disabled by default in Asia Pacific.
• Place your AirStation and wireless devices 2 - 10 feet apart.
• Restart your AirStation.
You forgot AirStation's SSID, Encryption Key, or
Password.
Hold down the reset button on the base of your AirStation for 3 seconds to initialize its settings. All
settings, including your password, SSID, and encryption key will be initialized to their defaults. The
factory defaults are:
SSID -
Encryption Type -
Encryption Key -
The link speed is slower than 300 Mbps (Maximum
link speed is only 130 Mbps).
By default, the AirStation's 300 Mbps mode is not enabled. You may enable it with the following
procedure:
1. Open the configuration interface (chapter 4).
2. In Easy Setup, click [Wireless SSID & Channel (11n 300 Mbps Mode)].
3. Change the value in [300 Mbps Mode] - [Bandwidth] to 40 MHz and click [Apply].
If you still cannot connect at 300 Mbps, check the settings of your wireless client devices.
WZR-HP-AG300H User Manual
BUFFALO-XXXXXX (the last 6 digits of the AirStation's MAC address) +
"_A" or "_G"
WPA/WPA2 mixed mode - PSK (Connect with either WPA-PSK TKIP or
WPA2-PSK AES).
Printed on the label of the AirStation.
BUFFALO-XXXXXX (the last 6 digits of the AirStation's MAC address) +
"_A" or "_G"
WPA/WPA2 mixed mode - PSK (Connect with either WPA-PSK TKIP or
WPA2-PSK AES).
Printed on the label of the AirStation.
(Encryption is disabled by default for Asia Pacific AirStations.)
109