WZR-HP-G300NH Router Settings (For: Pccw, HGC PPPoE User)
Hardware Setup of WZR-HP-G300NH Router:
1.
Set Router switch to "ON".
2.
Power on Buffalo Router, and wait for 2 minutes.
The "Power", "Security", "Wireless" and "Router" indicators will be
ON, and "Diag" will be OFF.
3.
To reset the router, please insert "RESET" hole by a paper clip for about
10 seconds, and wait for 2 minutes. The "Power", "Security", "Wireless"
and "Router" indicators will be ON, and and "Diag" will be OFF.
Last Updated 23/06/2009
Hornington KB: http://kb.hornington.com
:
4. Please connect your broadband service with a network cable (or from
DSL modem) to the "INTERNET" port on the ROUTER. Then use
another network cable to connect "LAN1" port on the ROUTER to the
Ethernet adapter on your PC. Make sure indicators "INTERNET" and
"LAN1" near lan ports are ON.
5.
Wait for 1 minute.
WZR-HP-G300NH PPPoE Settings
Page 1