Cisco OptoStar II Installation Manual page 9

Rf switch module
Table of Contents

Advertisement

Important Safety Instructions, Continued
Equipment Placement
WARNING:
Avoid personal injury and damage to this equipment. An unstable mounting
surface may cause this equipment failure.
To protect against equipment damage or injury to personnel, comply with the
following:
• Install this equipment in a restricted access location.
• Do not install near any heat sources such as radiators, heat registers, stoves, or
other equipment (including amplifiers) that produce heat.
• Place this equipment close enough to a mains AC outlet to accommodate the
length of this equipment's power cord.
• Route all power cords so that people cannot walk on, place objects on, or lean
objects against them. This may pinch or damage the power cords. Pay particular
attention to power cords at plugs, outlets, and the points where the power cords
exit this equipment.
• Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with this equipment.
• Make sure the mounting surface or rack is stable and can support the size and
weight of this equipment.
• The mounting surface or rack should be appropriately anchored according to
manufacturer's specifications. Ensure this equipment is securely fastened to the
mounting surface or rack where necessary to protect against damage due to any
disturbance and subsequent fall.
Ventilation
This equipment has openings for ventilation to protect it from overheating. To
ensure equipment reliability and safe operation, do not block or cover any of the
ventilation openings. Install the equipment in accordance with the manufacturer's
instructions.
Rack Mounting Safety Precautions
Mechanical Loading
Make sure that the rack is placed on a stable surface. If the rack has stabilizing
devices, install these stabilizing devices before mounting any equipment in the rack.
WARNING:
Avoid personal injury and damage to this equipment. Mounting this equipment
in the rack should be such that a hazardous condition is not caused due to
uneven mechanical loading.
viii
Safety
Continued on next page
OL-29669-01

Advertisement

Table of Contents
loading

Table of Contents