Table of Contents
Advertisement
24
What to do if ...
What to do if ...
Troubleshooting by yourself
If, during operation, the dryer shows an error (one or more leds flashing on the
control panel), check first of all whether you can remedy the problem yourself by
means of the table below. If you cannot solve the problem: Switch the machine off
and on again. Reset programme. Press the START PAUSE START PAUZE button. If
the error is still shown, please contact our after-sales service and inform them
which leds are flashing.
Problem
Dryer does not work.
Drying results
unsatisfactory.
Loading door does not
close.
Possible cause
Mains plug is not plugged in or fuse
is not working correctly.
Loading door is open.
Have you pressed the START PAUSE
START PAUZE button?
Wrong programme selected.
Lint filters clogged.
Fluff filter clogged.
Heat exchanger clogged with lint.
Overloading of laundry.
Ventilation slots in base area cov-
ered up.
Residue on inside surface of drum
or drum ribs.
Conductance of water at installa-
tion site differs from standard set-
ting of machine.
Fine strainer not in place and/or
mesh filter not locked in place.
Remedy
Plug in at mains socket. Check fuse
in fuse box (domestic installation).
Close loading door.
Press the START PAUSE START
PAUZE button again.
Select a different programme the
next time you dry (see "Programme
chart" chapter).
Clean lint filters.
Clean fluff filter.
Clean heat exchanger.
Observe recommended loading vol-
umes.
Uncover ventilation slots in base
area.
Clean inside surface of drum and
drum ribs.
Re-programme standard setting
for degree of drying (see 'Machine
settings' chapter).
Install fine strainer and/or snap
large mesh filter into place.
Hide quick links:
Advertisement
Table of Contents
