Routine Maintenance - AEG Electrolux 320TDGM Use And Installation Instructions

Routine maintenance

WARNINGS
Before performing any repair or operation, switch the appliance off and close
the gas tap.
The manufacturer declines all responsibility for any damage to persons, animals or
things caused by failure to observe the rules indicated above.
Have the condition and efficiency of the gas pipe and the pressure regulator (if installed)
checked periodically.If anomalies are found, do not request repairs but have the faulty
part replaced.
To ensure good performance and safety, the gas regulator taps must be greased
periodically.
Periodic lubrication of the taps must only be carried out by qualified staff, who
must also be contacted if the appliance malfunctions.
X) The hob is fixed in its upper part to the burners by
means of some visible screws. If these screws are
screwed, it is possible to open the appliance and to
reach the inside components (see picture below).
GREASING OF TAPS
If a tap becomes hard to be turned, grease it using a
specific grease withstanding high temperatures.
Act as follows:
- Switch the appliance off and close the gas tap.
- Remove knobs, grids, burners and flame-spreaders.
- Follow the indications od point ( X ).
- Unscrew the two fixing screws V from the burner body
A (see picture) and remove the cone C
- Clean the cone C and its slot by means of a cloth
soaked with diluent.
- Slightly grease the cone with the relevant grease, put
it in its slot, and turn it some times.
- Remove the cone again, remove the exceeding grease making sure the gas entries
are not obstructed by grease residuals.
- Assemble everything carefully in the opposite direction.
18
GB
V V
C
A
AR
V V
C
A
18