Electrical Connection - AEG Electrolux 320TDGM Use And Installation Instructions

Electrical connection

This appliance must be earthed by law
The appliance is prefitted to operate with a power supply voltage of 230 V singl-
ephase.The connection must be made in accordance with the regulations and laws
in force.
Before making the connection, make sure that:
1) the safety circuit-breaker and the electrical system are able to withstand the load
of the appliance (see nameplate).
2) the power supply system has an earth connection in good working order in
accordance with the regulations in force;
3) the socket or omnipolar switch used are easily accessible with the appliance
installed.
Fit a plug suitable for the load on the power lead and connect it to a suitable safety
socket.
If you wish to make a direct connection to the mains, an omnipolar switch with a gap
between the contacts of at least 3 mm, of suitable rating for the load and complying
with the regulations in force, must be installed between the appliance and the mains.
The switch must not break a contact in the yellow/green earth wire.
The brown live wire (connected to the "L" terminal of the terminal board) must always
be connected to the live wire of the power supply mains.
In all cases, the power supply lead must be positioned so that it does not reach a
temperature 50 C above the room
temperature in any point.
One example of an ideal route is
shown in the illustration.The cable
is guided by means of band
clamps fixed to the side of the
cabinet, in order to avoid any
contact with the appliance un-
derneath the hob.
Replacing the power supply lead
If the lead has to be replaced, only HO5RR-F or HO5RN-F type cables suitable for
the load and the operating temperature must be used.In addition, the yellow/green
earth wire must be about 2 cm longer than the live and neutral wires.
TYPES OF SUPPLY CABLE
Appliance Single-phase supply 230V~
type Type of cable
All gas Rubber H05 RR-F
2 electric plate Rubber H05 RR-F
14
COPPER PIPE OR
NO
YES
STAINLESS STEEL
HOSE
BAND CLAMPS
Service
opening in
cabinet
REAR VIEW
REAR VIEW
Section
3 x 0,75 mm 2
3 x 1,5 mm 2
live
Earth (Yellow/Green)
GB AR
Neutral
BLU
14