Table of Contents
Advertisement
3.7 EQ View
This is a view which allows you to view and adjust the EQ parameters for a channel.
Right-click in the fader
area of a channel.
The word "Equalizer" will
appear in a pop-up menu.
The on-screen rotary controls or the small up/down arrows to the right of the text boxes may be used to make
the gain, frequency and Q settings for the four EQ bands. The graphic EQ response curve will change as the
values are changed. The desired values could also be typed in directly. The software will round the values
to the nearest valid value used by the TM-D4000. Changing the EQ settings on the mixer itself will also change
the on-screen settings and the response curve.
NOTE: Some of the controls may be disabled under certain conditions. The Q setting has
no meaning when an HPF or LPF setting is selected in the Gain section of bands 1 and 4.
3.8 Aux Views
Settings for the TM-D4000's six Aux. Sends may be viewed and
adjusted from this screen. These on-screen controls are available
in two different views: Aux View (Ch01-16) and Aux View (Ch17-
32). The Aux settings for the two ST IN inputs are shown in both
views.
Use the View menu to select either of these two views. Note that
both views may be on the screen at the same time.
Click any of the PRE/POST or ON/OFF buttons to change these
settings.
The automation mode indicators show the current automation
mode of the channels.
The Aux. Send levels may be adjusted using the on-screen controls.
Channel labels entered in the Mixer View are shown but may not
be edited here.
Software Overview
Click on this pop-up to bring the
window shown above to the front.
The EQ button at the upper right
of the response curve can be used
to turn the EQ on or off for the
selected channel.
Alternatively, use the pull-down
list at the top of the window to
change between channels.
11
Hide quick links:
Advertisement
Table of Contents
