Setup; Windows Skills Required; System Requirements; Upgrading The Tm-D4000 Firmware - Tascam TM-D4000 Operation Manual

Dynamic mix automation
Hide thumbs Also See for TM-D4000:
Table of Contents

Advertisement

Setup

2.1 Windows Skills Required

This manual assumes that you already possess basic Windows operating skills (pointing,
clicking, dragging, menus, dialogs, etc. If you have just purchased your first PC for the
purposes of automating the TM-D4000, we recommend that you first read the introductory
manuals that came with your computer before starting to use the automation system.

2.2 System Requirements

In order to use the TM-D4000 automation software, your system must meet the following
requirements:
· Running Windows 95 or Windows 98
· 233 mHz or better Pentium II processor.
· 32 MB or more of RAM (64 MB recommended)
· Display of at least 1024 x 768 resolution
· Available ISA slot for the installation of the Moxa CI-132 card
· The Moxa CI-132 high-speed RS-422 board supplied with the TM-D4000 must be installed.
The software requires about 5 MB of disk space, in addition to any disk space you will use for
storing mixes.
NOTE: The software does not run under Windows 3.1 or any version of Windows NT.
To use this software you must use the special 9-pin cable supplied with the TM-D4000. This
cable is connected to one of the ports of the Moxa CI-132 RS-422 board also supplied with
the TM-D4000. A standard serial cable will not work.
NOTE: You cannot use the standard RS-232 serial port of your PC. You must use a Moxa
CI-132 board as supplied with the TM-D4000. If you are going to run the software on more
than one computer, you must purchase another card from Moxa Technologies or their
representatives in your country. See http://www.moxa.com for details

2.3 Upgrading the TM-D4000 Firmware

The TM-D4000 must be running system firmware version 1.10 or higher to run the automation
software. To check the firmware version on your mixer, press OPTION until the Setup screen
appears then press DIRECT.
Please refer to section 10-8 of the TM-D4000 Owner's Manual for complete instructions on
upgrading the firmware which can be downloaded from the TASCAM web site at
http://www.tascam.com
2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents