EPOX 3VBA Instructions Manual

Isa/pci agp motherboard with onboard pci ide and super multi-i/o

Advertisement

ISA/PCI AGP Motherboard with Onboard
PCI IDE and Super Multi-I/O
TRADEMARK
All products and company names are trademarks or
registered trademarks of their respective holders.
These specifications are subject to change without
notice.
Manual Revision 2.0
April 26, 1999

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 3VBA and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for EPOX 3VBA

  • Page 1 ISA/PCI AGP Motherboard with Onboard PCI IDE and Super Multi-I/O TRADEMARK All products and company names are trademarks or registered trademarks of their respective holders. These specifications are subject to change without notice. Manual Revision 2.0 April 26, 1999...
  • Page 2 (2) independent high performance PCI IDE interfaces capable of supporting PIO Mode 3/4 and Ultra DMA 33/66 devices. The 3VBA supports (4) PCI Bus Master slots and a jumperless PCI INT# control scheme which reduces configuration confusion when plugging in PCI card(s).
  • Page 3 3VBA Features • Supports the (4) Universal Serial Bus (USB) Ports. The onboard VT82C686A chip provides the means for connecting PC peripherals such as; keyboards, joysticks, telephones, and modems. • Built-in ATX 20-pin power supply connector. • ® Software power-down when using Windows 95/98.
  • Page 4 3VBA Installation 3VBA Detailed Layout Figure 1 Page 3...
  • Page 5: Device Connectors

    3VBA Installation The following must be completed before powering on your new system: Configure DIP Switch and Jumper to match your hardware System memory Configuration Device Connectors We design this motherboard with a DIP Switch to make your install fast and easy.
  • Page 6 3VBA Installation The 3VBA supports (3) 168-pin DIMMs (Dual In-line Memory Module). The DIMMs can be either EDO (Enhanced Data Out) or SDRAM (Synchronized DRAM). • DIMM SDRAM may be 83MHz (12ns), 100MHz (10ns) or 125MHz (8ns) bus speed. •...
  • Page 7 3VBA Installation Please install the motherboard into the chassis. Now that your motherboard is installed you are ready to connect all your connections (figure 6). Joystick /Midi port parallel port PS/2 Mouse USB port PS/2 KEYBOARD COM1 COM2 Speaker Line_in...
  • Page 8 3VBA Installation Power LED connector 1. Power LED(+) 4. NC 2. N/C 5. GND 3. GND Speaker - Connect to the system's speaker for beeping 1. Speaker 3. GND 2. N/C 4. GND Reset - Closed to restart system. IR Connector 1.

Table of Contents