Cleaning The Grill/ Oven Compartments - AEG COMPETENCE 5212 BU Operating Instructions Manual

TO REPLACE THE OUTER
DOOR GLASS
1. Holding the door glass panel with both hands,
gently place the locators into the holes of the
brackets at the bottom of the oven door.
2. Holding the door glass with your left hand,
use your right hand to open the oven door.
Bring the door gently towards the glass panel
ensuring the screw location holes line up.
3. Place the trim in the correct position on the
top of the grill door.
4. Hold the glass in place with one hand and
insert the cross head screws with washers
into the location holes with the other hand.
Give the screws one turn to ensure the glass
is secure.
5. Tighten the screws positively with a Pozidrive
screwdriver before closing the oven door.
DO NOT attempt to use the oven
without the glass being in place.
TO CLEAN THE INNER GLASS
DOOR
The inner glass door is not removable. Clean
using hot soapy water or Hob Brite and a soft
cloth. DO NOT use abrasives as they may
damage the glass or seal.
CLEANING THE GRILL/ OVEN
COMPARTMENTS
The oven tops, sides and back panels are
coated with a Stayclean finish.
The Stayclean areas in the ovens should not be
cleaned manually.
Follow the procedure below to maintain the
appearance of the Stayclean finish.
The oven bases can be cleaned using normal
oven cleaners or aerosol oven cleaners with
care. Ensure that
instructions are followed and that all parts are
well rinsed afterwards.
Do not use any cleaning agents or scrapers on
the oven tops, sides, back panels and door
seals.
Damage will occur if soap impregnated steel
wool pads, aerosol cleaners or any abrasive
cleaners are used.
44
the manufacturers