To Replace The Inner Glass Panel; Cleaning The Grill And Oven Furniture; Replacing An Oven Light Bulb - AEG COMPETENCE CD21601-M Operating Instructions Manual

Do not clean stainless steel outer
panels (where fitted) with Hob Brite as
damage to the finish will occur. See
cleaning instructions for stainless steel
models on page 24.
TO REPLACE THE INNER GLASS
PANEL
1. Holding the glass panel in your right hand fully
open the oven door with your left.
2. Gently ease and push the glass into the
location points under
lowering and sliding the glass into position
under the hinge location points at the rear.
Ensure the glass is properly located and the text
'This way up' is facing towards you and at the top
edge of the door.
Do not attempt to use the oven without
the glass being in place.
CLEANING THE GRILL AND OVEN
FURNITURE
All removable parts, except the grill pan handle can
be washed in the dishwasher.
The grill pan, grill pan grid, meat tin and oven
shelves may be cleaned using a soap impregnated
steel wool pad. Soaking first in hot soapy water will
make cleaning easier.

REPLACING AN OVEN LIGHT BULB

The type of bulb required is a 300°C 25 watt small
Edison Screw.
(Available through Service Force Centres).
Disconnect the appliance from the
electricity supply before replacing the
bulb.
1. Make sure the appliance is cool before
replacing the bulb.
2. Open the oven door and remove the shelves
and wirework runners.
Instructions on how to remove the wirework
runners are given on page 24.
3. Pull the glass bulb cover towards you and then
pull it off. If necessary, use a screwdriver to
carefully lever off the cover, taking care not to
damage the oven cavity.
4. Unscrew the bulb by turning it to the left.
5. Fit a new bulb and then replace the glass bulb
cover.
6. Replace the oven shelves.
7. Restore the electricity supply and reset the time
of day.
the handle before
26