Where To Look For Blockages - Dyson DCO7 Owner's Manual

Where to look for
blockages
CAUTION
• Disconnect the machine from
the electrical outlet before
starting to look for blockages.
Failure to do so could result
in electric shock or personal
injury.
Please note: Should any part of
the machine become blocked,
the motor may overheat and stop
due to the thermal cut-off being
triggered. Disconnect from
electrical outlet and let the
machine cool down for at least
30 minutes before clearing the
blockage.
Tools Wand
Check that the tools are clear of Press the wand release button to
blockages. remove the wand from the hose.
Check inside wand for blockages.
CAUTION
• Beware of sharp objects
when clearing blockages.
1 - 866 - 693 - 9766
Dyson Helpline contact us on
14
A
B
Hose U-bend airway inspection
A Press the cyclone release catch • Tilt the machine forward to
to remove the clear bin slide out the U-bend airway
assembly from the machine. inspection.
B Press the hose release button • Check inside for blockages.
from the front of machine and
slide the hose out from the
rear, holding the lower cord
winder. Check inside the hose
for blockages.
CAUTION
• The ratchet noise warns that
the brushbar is obstructed.
Disconnect the machine from
the electrical outlet before
removing the obstruction.
1
2
Airway inspection valve Brushbar
• Squeeze the valve release Lay the machine on its front.
catches to remove the airway
1 Undo the colored soleplate
inspection valve.
fasteners using a coin and
• Check inside for blockages. remove the soleplate.
2 Clear the brushbar
obstruction, carefully cutting
away any threads with a pair
of scissors.
Replace the soleplate and tighten
the fasteners.
CAUTION
• Make sure all parts have
been replaced securely
before using your machine.
15