Where To Look For Blockages - Dyson DCo7 Owner's Manual

Where to look for
blockages
CAUTION
• Disconnect the machine from
the electrical outlet before
starting to look for blockages.
Failure to do so could result
in electric shock or personal
injury.
Please note: Should any part of
the machine become blocked,
the motor may overheat and stop
due to the thermal cut-off being
triggered. Disconnect from
electrical outlet and let the
machine cool down for at least
30 minutes before clearing the
blockage.
Tools Wand
Check that the tools are clear of Press the wand release button to
blockages. remove the wand from the hose.
Check inside wand for blockages.
CAUTION
• Beware of sharp objects
when clearing blockages.
1 - 866 - 693 - 9766
Dyson Helpline contact us on
14
All manuals and user guides at all-guides.com
A
B
Hose
A Press the cyclone release catch
to remove the clear bin
assembly from the machine.
B Press the hose release button
from the front of machine and
slide the hose out from the
rear, holding the lower cord
winder. Check inside the hose
for blockages.
U-bend airway inspection Airway inspection valve
• Tilt the machine forward to • Squeeze the valve release
slide out the U-bend airway catches to remove the airway
inspection. inspection valve.
• Check inside for blockages. • Check inside for blockages.
CAUTION
• The ratchet noise warns that
the brushbar is obstructed.
Disconnect the machine from
the electrical outlet before
removing the obstruction.
1
2
Brushbar
Lay the machine on its front.
1 Undo the colored soleplate
fasteners using a coin and
remove the soleplate.
2 Clear the brushbar
obstruction, carefully cutting
away any threads with a pair
of scissors.
Replace the soleplate and tighten
the fasteners.
CAUTION
• Make sure all parts have
been replaced securely
before using your machine.
15