Clearing Blockages - Dyson micro User Manual

Clearing blockages

If your machine detects a blockage, the motor will pulse six times. You
won't be able to use your machine until the blockage has been cleared.
If you try to use your machine when the motor is pulsing, it will
automatically cut out.
Leave your machine to cool down before looking for blockages.
Disconnect your machine from the charger before looking for blockages.
Be aware of sharp objects.
Leave your machine to cool down before looking for blockages.
Don't use your machine when looking for blockages as this could cause
injury.
With the bin removed,
check for blockages,
paying particular atten-
tion to the air inlet, locat-
ed at on the right–hand
side of the machine just
below the point where
the bin joins the main
body of the machine.
Check for blockages in
the filter end and bin
ends of the machine.
The bin being removed
and the location of the bin
release lever on the under-
side of the bin runner.
Turn the cleaner head over to
check for obstructions on the
brush bar and air inlet.
Remove any obstructions
from the brush bar.
With the wand
removed from
the machine,
check for
blockages at
both ends of
the wand.