Electrical Connection - Candy TRIO 501 Installation Manual

INSTALLATION - ELECTRICAL CONNECTION
"The installation must conform to the standard directives".
CANDY declines all responsibility for any damage that may be caused by unsuitable or
unreasonable use.
Warning :
• Always check before any electrical operation, the supply tension shown on the electricity
meter, the adjustment of the circuit-breaker, the continuity of the connection to earth to
the installation and that the fuse is suitable.
• The electrical connection to the installation should be made via a socket with a plug
with earth, or via an omni pole cut-out switch with an opening gap of at least 3 mm.
If the appliance has a socket outlet, it must be installed so that the socket outlet is
accessible.
CANDY cannot be held responsible for any accidents resulting from the use of an
appliance which is not connected to earth, or with a faulty earth connection continuity.
• Any queries regarding the power supply cord should be referred to After Sales
Service or a qualified technician.
Warning! This appliance must be earthed. In the absence of adequate earthing you
will notice that when touching the metal parts of your appliance an electrical
dispersion can be felt due to the presence of a radio interference suppressor.
A power cord is supplied with the Trio which allows it to be connected only to a power
supply of 230 V between phases, or between phase and neutral. Connect to a 10/16 Amp
socket.
If the gas type has been altered, the stability of the flame in the minimum flow must be
checked and set by adjusting the by-pass screw.
o access the top burner by-pass screw, remove the control panel knobs. At first, pull the
T
disc to the front and remove the combined control knob.
a) Butane- propane gas : the setting is done by screwing right in (without forcing) the
by-pass screw whose calibrated hole provides the minimum flow.
b) Natural gas :
. unscrew the by-pass screw one turn,
. replace the combined control-knob, light the burner and set to low flame,
. remove the combined control-knob again, screw the by-pass screw until a reduced flame is
obtained, staying stable when going from high to low position.
. replace the combined control-knob.
34
SETTING THE IDDLE FLAME
Never loosen the others screws !
Warning :