Epson R-D1 User Manual page 8

❏ The battery charger included is designed for use with this product.
Use of any other battery charger could result in fire, electrical shock,
or injury.
❏ Use only a power source that meets the power requirements
indicated on the label attached to the product. If you are not sure
of the power supply specifications in your area, contact your local
power company or contact our Customer Support.
❏ Make sure the total amperage of all devices plugged into the power
outlet does not exceed the power outlet's ampere rating.
❏ If you plan to use this product in Germany, the building installation
must be protected by a 16 amp circuit breaker to provide adequate
short-circuit protection and over-current protection for this
product.
❏ Do not use a damaged or frayed battery charger.
❏ If you use an extension cord with this product, make sure the total
amperage of all devices plugged into the extension cord does not
exceed the cord's ampere rating.
❏ Never disassemble, modify, or attempt to repair the battery charger
by yourself except as specifically explained in this guide.
❏ Do not use power outlets controlled by wall switches or automatic
timers.
❏ Do not use power outlets on the same circuit as large motors or
other appliances that may cause voltage fluctuations.
❏ Avoid using outlets on the same circuit as photocopiers or air
conditioning systems that regularly switch on and off.
❏ Position this product's power cord so that it will not be stepped on
or run over.
❏ Do not place any objects on the power cord or the battery charger.
❏ Keep the power cord straight at the ends and at the points where
it enters the transformer.
❏ The power cord should be placed to avoid abrasions, cuts, fraying,
crimping, kinking, and other damage.
8
Introduction
❏ If you cannot insert the plug into the power outlet, contact an
electrician.
For US and Canadian users:
Use the power cord provided or a 6 to 10 foot UL-approved type SPT-2
or heavier type, 2 X 18 AWG cord with a 125 V 10 A plug and 125 V 7
A connector.
When using a memory card
❏ Only memory cards designed for the product's specifications can
be used.
❏ The methods for using memory cards vary according to card type.
Be sure to refer to the documentation included with your memory
card for details.
❏ Do not remove the memory card while the power switch is on.
When using the LCD
❏ The LCD monitor on this product may contain a few small bright
or dark spots. These are normal and do not mean that your LCD
monitor is damaged in any way.
❏ If the LCD monitor on this product is damaged, consult your
dealer.
❏ If the liquid crystal solution contained in the LCD monitor on this
product leaks out and gets onto your hands, wash them thoroughly
with soap and water. If it gets into your eyes, flush them
immediately with water. If discomfort or vision problems remain
after a thorough flushing, see a doctor immediately.
❏ Only use a soft, dry cloth to clean the display. Do not use liquid or
chemical cleaners.
When storing, maintaining, or transporting the
camera
❏ Do not store this product outdoors.