Operating Sequence - Electrolux EDC 5320 Instruction Booklet

125992620 gb.qxd 18/02/2004

Operating sequence

Before using your tumble dryer for the first time, we
recommend to place a few damp cloths inside the
appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door (see picture).
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does
not get caught between the door and filter.
5. Select the drying programme or time. The lights
, and
"START/PAUSE"
6. If required, press the low temperature button
and/or the "Buzzer OFF"
"Quick drying" button
.
7. Press the "START/PAUSE"
corresponding light stops flashing and drying
starts. Only the light
If the programme selector dial is turned to
another position, when the machine is running,
the buzzer will sound, the programme phase
indicator lights will flash.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase light
You may remove the laundry after this phase.
16:31 Pagina 9
come on. The light of the
button flashes.
button or the
button the
remains lit.
is on).
The lights , and
8. If the laundry is not removed at the end of the
cycle, the dryer performs an anti-creasing
phase (duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will stop
automatically at the end of the anti-creasing phase.
Lights , and remain lit and the buzzer
sounds every 10 seconds for 2 minutes.
The light of the "START/PAUSE"
off.
9. Turn the programme selector dial to "0"; all the
lights go out. The appliance is switched off.
Remove the laundry.
If you open and then close the door before
turning the selector dial to "0" all the lights
corresponding to the phases making up the
performed programme come on.
After each use
• Clean the filters (see page 11).
• Empty the water reservoir (see page 12).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position
until the end of this cooling phase before removing
the laundry. This will avoid a build-up of heat inside
the appliance.To do this first turn the dial to "0" and
then to and depress "START/PAUSE"
Modifying the programme
To change a programme which is running, first
cancel it by turning the programme selector dial to
"0". Select the new programme and press the
"START/PAUSE" button.
9
illuminate.
button goes
and wait
button .